Endurocross! 2018

Postby **Native** » Fri Feb 23, 2018 5:41 pm

Sounds great, Jason!

Philip ???

twistedwankel · Postby **twistedwankel** » Fri Feb 23, 2018 5:53 pm

JasonS wrote:Studs swapped and hub reassembled. Now to throw the caliper on slam the wheels on and good to go. Will be bringing my torque wrench to tighten tomorrow as needed just in case.

When I get a newer car I always put a small bit of neverseize on the studs being careful not to get any on the seating surface of the lug nuts. It makes the torque wrench ever so much more accurate and I've never had a binding issue yet in decades. Your car is only 2 years old in FL and the nuts seized? Yikes. It's not like you left them on for two years in the sea salt. Glad you got it sorted out.

Wonder if the dealer would have fixed it for free? Wonder where the OEM stuff came from? N. Korea I bet.

Carracer · Postby **Carracer** » Fri Feb 23, 2018 9:27 pm

Native wrote:Sounds great, Jason!

Philip ???

Just fixing some some stuff.
BTW, I know we can't have a car leaking oil but what about a fuel injector spraying gas? I figure if I dump a enough fuel it will make the car lighter and Loren has shown that 3 cylinder is all you need.

JasonS · Postby **JasonS** » Fri Feb 23, 2018 9:33 pm

Car is ready. Did some reflector slalams (on a deserted road). All is well.

McMastaHompus · Postby **McMastaHompus** » Fri Feb 23, 2018 10:55 pm

Do some late night prep, to find my rear tires are totally camber worn, I know it's a long shot, but does anyone have access to a tire machine so I can flip my tires and run them tomorrow?

Carracer · Postby **Carracer** » Fri Feb 23, 2018 11:07 pm

So I'm now looking for a co-drive. I have cash and a bad Miata fuel injector.

Postby **Loren** » Fri Feb 23, 2018 11:07 pm

Y'all are funny.

I'm goin' to bed.

Postby **Native** » Sat Feb 24, 2018 6:14 pm

And this one's been put to bed, as well.

Tell it goodnight here.

Who is online